Non-uniform granule size during wet granulation – inspection risk analysis
During production, operators may observe several signals indicating non-uniform granule size. These may include:Click to read the full article.
Tips for Equipment & Instrumentation Troubleshooting
Over-wetting observed after scale-up – inspection risk analysis
Over-wetting typically manifests in several observable signs during the granulation process. Professionals should monitor for the following symptoms:Click to read the full article.
Inadequate end-point detection during drying phase – process vs equipment root cause
Identifying the symptoms of inadequate end-point detection is crucial for initiating timely interventions. Indicators on the production floor or in the lab may include:Click to read the full article.
Granule attrition issue during inspection readiness – CAPA and control strategy gap
Identifying symptoms of granule attrition early can substantially mitigate risks associated with non-compliance. Common signals include:Click to read the full article.
RMG torque fluctuation during validation – CAPA and control strategy gap
The first step in addressing RMG torque fluctuations is recognizing the symptoms that indicate a potential problem. Common signals observed may include:Click to read the full article.
Non-uniform granule size during validation – CAPA and control strategy gap
The first step in addressing issues related to non-uniform granule size is to recognize the symptoms manifesting during production or validation runs. These symptoms can often signal underlying problems that…
RMG torque fluctuation after scale-up – process vs equipment root cause
The first step in addressing any equipment issue is recognizing the symptoms. Torque fluctuations in an RMG can manifest in various ways, including:Click to read the full article.
Over-wetting observed during inspection readiness – process vs equipment root cause
Identifying over-wetting in a manufacturing setting often starts with clear symptoms signaling a potential issue:Click to read the full article.
Over-wetting observed after scale-up – process vs equipment root cause
Recognizing the early indicators of over-wetting is critical for timely intervention. Symptoms may not only be observable in the batch itself but can also manifest in intermediate processes and equipment…
Binder spray nozzle blockage during validation – CAPA and control strategy gap
Detection of binder spray nozzle blockage frequently presents itself through several observable symptoms, which may vary based on the granulation equipment utilized. Typical indicators include:Click to read the full article.
Binder spray nozzle blockage during validation – process vs equipment root cause
Recognizing the symptoms of binder spray nozzle blockage during validation is the first critical step in resolution. Key signs may include:Click to read the full article.
FBD drying inconsistency during wet granulation – inspection risk analysis
Recognizing the symptoms of drying inconsistencies in fluidized bed dryers is crucial for timely intervention. Typical signs that indicate a potential issue include:Click to read the full article.