Granulation Equipment (FBD, RMG) Issues – Page 4

Granule attrition issue during wet granulation – CAPA and control strategy gap

Granule attrition during wet granulation may manifest through various observable signals on the production floor or laboratory settings. Typically, the following indicators will arise:Click to read the full article.

Granule attrition issue after scale-up – CAPA and control strategy gap

Symptoms of granule attrition commonly emerge as visible quality deviations during production processes or during laboratory evaluation of granulated material. Key signals may include:Click to read the full article.

Granule attrition issue during wet granulation – inspection risk analysis

Addressing Granule Attrition Issues in Wet Granulation: A Comprehensive Inspection Risk Analysis In pharmaceutical manufacturing, granulation processes play a crucial role in ensuring the quality and efficacy of solid dosage…

FBD drying inconsistency during wet granulation – process vs equipment root cause

Identifying symptoms of FBD drying inconsistency is the first step toward resolution. Common signals include:Click to read the full article.

RMG torque fluctuation during drying phase – process vs equipment root cause

Symptoms of torque fluctuation in RMG during the drying phase manifest in various forms. Key indicators include:Click to read the full article.

Inadequate end-point detection after scale-up – process vs equipment root cause

Identifying the symptoms of inadequate end-point detection is the first step towards effective troubleshooting. These signals can manifest in various ways on the production floor or in the laboratory:Click to…

FBD drying inconsistency during validation – CAPA and control strategy gap

Inconsistencies during FBD drying may manifest as:Click to read the full article.

FBD drying inconsistency during inspection readiness – inspection risk analysis

The first indication of a drying inconsistency can manifest through several symptoms, which should prompt immediate investigation. Common signs include:Click to read the full article.

Inadequate end-point detection during validation – inspection risk analysis

Inadequate end-point detection manifests in various ways. Understanding these symptoms is paramount for swift intervention. Here are some common indicators:Click to read the full article.

Over-wetting observed during inspection readiness – inspection risk analysis

The initial signs of over-wetting can manifest in various ways during different stages of the granulation process. Here are some common symptoms to be vigilant about:Click to read the full…

Binder spray nozzle blockage during drying phase – process vs equipment root cause

Recognizing the symptoms of binder spray nozzle blockage early is key to mitigating its impact. Common signs include:Click to read the full article.

Non-uniform granule size during drying phase – CAPA and control strategy gap

The first indication of non-uniform granule size often manifests during the drying phase or subsequent processing steps. Symptoms may include:Click to read the full article.