Granulation Equipment (FBD, RMG) Issues – Page 2

Granule attrition issue during drying phase – inspection risk analysis

Granule attrition typically manifests through various observable symptoms on the production floor or in quality control laboratories. Key indicators include:Click to read the full article.

Inadequate end-point detection during inspection readiness – CAPA and control strategy gap

Identifying the symptoms of inadequate end-point detection is the first step in addressing this issue. Key indicators may include:Click to read the full article.

Granule attrition issue after scale-up – process vs equipment root cause

The first step in addressing granule attrition is to recognize its symptoms. Signs may manifest during the mixing, granulation, or drying stages, and can include:Click to read the full article.

Non-uniform granule size during wet granulation – inspection risk analysis

During production, operators may observe several signals indicating non-uniform granule size. These may include:Click to read the full article.

Over-wetting observed after scale-up – inspection risk analysis

Over-wetting typically manifests in several observable signs during the granulation process. Professionals should monitor for the following symptoms:Click to read the full article.

Inadequate end-point detection during drying phase – process vs equipment root cause

Identifying the symptoms of inadequate end-point detection is crucial for initiating timely interventions. Indicators on the production floor or in the lab may include:Click to read the full article.

Granule attrition issue during inspection readiness – CAPA and control strategy gap

Identifying symptoms of granule attrition early can substantially mitigate risks associated with non-compliance. Common signals include:Click to read the full article.

RMG torque fluctuation during validation – CAPA and control strategy gap

The first step in addressing RMG torque fluctuations is recognizing the symptoms that indicate a potential problem. Common signals observed may include:Click to read the full article.

Non-uniform granule size during validation – CAPA and control strategy gap

The first step in addressing issues related to non-uniform granule size is to recognize the symptoms manifesting during production or validation runs. These symptoms can often signal underlying problems that…

RMG torque fluctuation after scale-up – process vs equipment root cause

The first step in addressing any equipment issue is recognizing the symptoms. Torque fluctuations in an RMG can manifest in various ways, including:Click to read the full article.

Over-wetting observed during inspection readiness – process vs equipment root cause

Identifying over-wetting in a manufacturing setting often starts with clear symptoms signaling a potential issue:Click to read the full article.

Over-wetting observed after scale-up – process vs equipment root cause

Recognizing the early indicators of over-wetting is critical for timely intervention. Symptoms may not only be observable in the batch itself but can also manifest in intermediate processes and equipment…